Connect ptpublisher to disc cover 3 how to#
Connect ptpublisher to disc cover 3 install#
Connect ptpublisher to disc cover 3 drivers#

Connect ptpublisher to disc cover 3 drivers#

TIP! For latest drivers versions please visit: 3Д¤ Section 3: Connect the esata cables The Disc Publisher BLU unit comes with one or two esata cables depending on the number of drives in your system.

Connect ptpublisher to disc cover 3 install#

Follow the installation wizard to install the driver. Double Click on the SiI3132_1.1.9u_Sil_Pkg.zip. Browse to the Macintosh folder on the disc. Insert the Installation CD into your CD/DVD drive. The computer will automatically download the appropriate driver from the internet. Choose Search Automatically for Updated Driver Software. Right Click on the Mass Storage Controller that appears under Other devices. Click on the Device Manager search result. To finish installing the driver, complete the steps of the wizard when prompted. Choose Install the software automatically (Recommended). Follow the instructions that apply to your Operating System. 2ДЈ Section 2: Installing esata software drivers Once the computer has started you will need to install the driver software for the esata card.

If you have a laptop, you may be able install an esata PCMCIA card or an express card in your laptop (Not included). It will not work with PC or Mac laptops, imacs or other all in one PCs.

Note on hardware compatibility: This esata card will work with any desktop PC or desktop Macintosh that has PCI Express card slots. Replace the cover, replace power and turn on the computer. Secure the card using the screws that came with the computer. Card Installed in x1 slot Card Installed in x16 slot 6. Be sure to remove any necessary blank card slot covers. Install the card in either the x1 or x16 slot. PCI slot separators are near the back of the cardДў 4. X16 PCI Express X1 PCI Express PCI Slots (Not Compatible) PCI Express slots are set back further than PCI slots PCI Express slot separators are near the front of the card. The included card will work with either type. Most computers will either have x1 or x16 slots.

PCI Express slots are usually set back from the case opening. Open the cover on your computer to access the card slots. Shut down your computer and disconnect power. Section 1: Disc Publisher BLU esata Card Installation Instructions 1. If you already have esata connections on your computer (not typical) skip to section 3 for connection instructions.

Connect ptpublisher to disc cover 3 how to#

The following instructions explain how to install the included esata card and connect the Disc Publisher to your computer using the included esata cable(s). In addition to the USB cable that must be connected as described in the setup instructions, you will also need to connect one or two esata cables from your Disc Publisher to your computer. 1 Important Note Regarding Your Blu ray Drives Use these supplemental instructions to complete the setup of your unit Your Disc Publisher unit uses esata to connect the Blu-ray drive(s) to the computer.